I have a Campbell Hausfield PW1345 electric pressure washer. It was working and then shut off. I turned the switch on and off but that didn't start it up. I have water pressure to the inlet hose and when I turn on the gun (without the compressor running) I have water spraying out. I couldn't get it to run by turning the switch off and on. I checked the power outlet and I had power. I unplugged the plug and plugged it back in. Still no results. I disconnected both inlet and outlet hoses, (about 5 minutes had elapsed since the compressor was running) and plugged the unit back in. I turned on the switch and the unit ran. I immediately turned it off, connected the inlet and outlet hoses, turned on the water pressure and then turned the unit back on. It worked for about 15 seconds and then shut off. I was unable to get it to power back up. Any ideas as to what to check? I've looked at your troubleshooting manuals and saw nothing there that would give me a clue.

Thanks for any help

Thanks for the quick reply. I'll try the the two tips in the manual and follow your suggestion by calling the tech rep. Thanks again!

I have water spaying out of the injector all the time

SUN JOE SPX3000 is one of the best pressure washers. Here are some best electric pressure washer reviews .