I just rebuilt my speedair 5Z185A

8 years 11 months ago #1368 by projet07
I just rebuilt my speedair 5Z185A was created by projet07
Not sure which valve plates go where, there are 3 different thickness

Please Log in or Create an account to join the conversation.

8 years 11 months ago #1369 by MTR-Admin
Replied by MTR-Admin on topic I just rebuilt my speedair 5Z185A
Thanks for the post!

I've attached installation instructions for the Valve Kit on this model, this gives you all of the information you need to install them correctly.

You have the Intake valves, which are the thinnest, then your Exhaust valves which are thicker. Lastly, you have the Valve Retainers, which are ridgid and install on top of the flapper valves.

Hope this helps!

- MTR
Attachments:

Please Log in or Create an account to join the conversation.

8 years 11 months ago #1370 by projet07
Replied by projet07 on topic I just rebuilt my speedair 5Z185A
my compressor has the intake valves in the head[the thin ones] and the exhaust are in the valve plate[ the thicker ones] do you still use the the ridgid ones on top of intake or exhaust valves?

Please Log in or Create an account to join the conversation.

8 years 11 months ago #1373 by MTR-Admin
Replied by MTR-Admin on topic I just rebuilt my speedair 5Z185A
I believe you would use the Retainers, which would be installed on top of the thicker Exhaust Valves.

If your valve didn't have these Retainers, however, then there is no need to use them.

Hope this clears it up.

- MTR
The following user(s) said Thank You: projet07

Please Log in or Create an account to join the conversation.

8 years 11 months ago #1374 by projet07
Replied by projet07 on topic I just rebuilt my speedair 5Z185A
I would like to thank you guys for all the help !! THANKS

Please Log in or Create an account to join the conversation.

8 years 11 months ago #1375 by MTR-Admin
Replied by MTR-Admin on topic I just rebuilt my speedair 5Z185A
You're certainly welcome, and happy compressing! :)

- MTR

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.059 seconds