pressure washer stalls when engine is started

9 years 4 months ago #1092 by bob1190
pressure washer stalls when engine is started was created by bob1190
there's a one way valve in the output line. if I remove it and put it back, then turn the water on before starting the engine, I have low pressure. No hose or wand connected. I start the engine and the engine stalls. no water comes out unless I remove the valve .

Originally I found a bad 'o'ring in the unloader. This is a rmv 2.5g30 pump

???

Thanks for your input,

Bob

Please Log in or Create an account to join the conversation.

9 years 4 months ago #1093 by bob1190
Replied by bob1190 on topic pressure washer stalls when engine is started
One way valve was stuck/or jammed. I replaced it and adjusted pressure. Working ok now

Please Log in or Create an account to join the conversation.

9 years 4 months ago #1094 by MTR-Admin
Replied by MTR-Admin on topic pressure washer stalls when engine is started
Thanks for the post, and glad you found the fix!

I was going to suggest the same, good to see you found it first. Feel free to post here if you have any additional questions or comments.

- MTR

Please Log in or Create an account to join the conversation.

9 years 4 months ago #1095 by bob1190
Replied by bob1190 on topic schematic
Does anyone have a schematic of a typical pressure waster pump and valve system ?

Thanks ,

Bob

Please Log in or Create an account to join the conversation.

9 years 4 months ago - 9 years 4 months ago #1096 by MTR-Admin
Replied by MTR-Admin on topic schematic
Bob, I've attached the breakdown for this pump (at least it's very similar).
Hope this helps.

You can also view this on our website with the parts list by clicking on the below link:

www.mastertoolrepair.com/medium-duty-axi...25g30d-p-658614.html
- MTR
Attachments:
The following user(s) said Thank You: bob1190

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.058 seconds