No water floe thru pump BM80915

9 years 6 months ago #988 by rickfd2
No water floe thru pump BM80915 was created by rickfd2
After using the unit for 2 hrs the washer stopped. The engine still runs but without the engine running , no water flows thru the pump. what to check?

Please Log in or Create an account to join the conversation.

9 years 6 months ago #989 by MTR-Admin
Replied by MTR-Admin on topic No water floe thru pump BM80915
Thanks for the post!

Just to confirm, the engine will keep running but no water will run through the pump itself?

If you can give a little more detail I'm sure I can help you out.

Thank you,

- MTR

Please Log in or Create an account to join the conversation.

9 years 6 months ago #990 by rickfd2
Replied by rickfd2 on topic No water floe thru pump BM80915
I was using the unit and it was working fine the suddenly everything stopped. I checked the engine and it started and ran fine. I checked the water flow from the hose and it was good. With the engine off and the wand disconnected there is usually water flowing thru the pump and out of the connection for the wand. That has ceased.

Please Log in or Create an account to join the conversation.

9 years 6 months ago #991 by MTR-Admin
Replied by MTR-Admin on topic No water floe thru pump BM80915
I would say if there is no obvious restriction visible in the input or output ports then I would say there is an internal pump problem. Since there are no parts available for this pump it may be time to replace the pump. You can take the valve body off and check for an obvious problem, just be careful with the seals.

There may be debris inside the pump and you can try cleaning it up a bit once you take the valve body off.

- MTR

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.050 seconds