- Posts: 1
- Karma: 1
- Thank you received: 0
Chainsaw on a pole help needed
- JeffL
- Topic Author
- Offline
- Fresh Boarder
-
Less
More
8 years 5 months ago #1730
by JeffL
Chainsaw on a pole help needed was created by JeffL
I have a Remington RM0612P Branch Wizard. The motor runs, but the chain doesn't move. I opened it up, and found there is a worm gear from the motor, that turns another gear that slides over a shaft connected to the chain sprocket gear. The problem is that there is nothing locking that sprocket gear shaft to the gear that is turned by motor's work gear. So that gear just spins around on the sprocket gear shaft. Is there anyway to fix this?
Please Log in or Create an account to join the conversation.
- MTR-Admin
-
- Offline
- Administrator
-
Less
More
- Posts: 1196
- Karma: 15
- Thank you received: 95
8 years 5 months ago #1744
by MTR-Admin
Replied by MTR-Admin on topic Chainsaw on a pole help needed
Thanks for the post!
I found a schematic online at the below link, just copy and paste it in your browser:
file:///C:/Users/User/Downloads/769-06113.pdf
It's not very detailed, but hopefully this will help you out. I don't have very much experience myself with this type of equipment, but I'll do what I can to dig up some information.
- MTR
I found a schematic online at the below link, just copy and paste it in your browser:
file:///C:/Users/User/Downloads/769-06113.pdf
It's not very detailed, but hopefully this will help you out. I don't have very much experience myself with this type of equipment, but I'll do what I can to dig up some information.
- MTR
Please Log in or Create an account to join the conversation.
Moderators: MTR-Admin
Time to create page: 0.059 seconds