Craftsman 10 inch miter saw

10 years 10 months ago #815 by jake2leea
Craftsman 10 inch miter saw was created by jake2leea
Has anyone had any experience in replacing the arbor gear on a craftsman saw with a discontinued part listing? The saw is a 113.235200, the part is a 823251. Discontinued from sears. The gear on the arbor has a broken tooth, so all I really need is the gear. I'm not aware of any companies that can machine a new gear, but i'm sure it's been done before. Any suggestions would be greatly appreciated.

Please Log in or Create an account to join the conversation.

10 years 10 months ago #817 by MTR-Admin
Replied by MTR-Admin on topic Craftsman 10 inch miter saw
There isn't a whole lot you'd be able to do at this point I'd imagine, unfortunately.

I would check eBay, but even then it's a crapshoot.

A machine shop would probably charge as much for a new arbor gear as a new saw, honestly. I'll do some further research and if I get any positive hits at all, I'll reply and let you know.

Good luck and thanks for posting!

- MTR

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.056 seconds