Porter Cable BN200A

5 years 7 months ago #3054 by Ermanno
Porter Cable BN200A was created by Ermanno
It doesn’t shoot nails in completely, I adjusted it and turned up the pressure still won’t go in all the way.
I’m wondering if there’s a seal or “O” ring missing, parts diagram are not very precise.
Anyone have an idea.

Please Log in or Create an account to join the conversation.

5 years 7 months ago #3055 by skatingtoolman
Replied by skatingtoolman on topic Porter Cable BN200A
Is the tip of the driver blade broken? Those parts are available at this link below:

www.ereplacementparts.com/porter-cable-b...c-129_1717_2145.html

Please Log in or Create an account to join the conversation.

5 years 7 months ago #3058 by Ermanno
Replied by Ermanno on topic Porter Cable BN200A
The tip is good, any other ideas.

Please Log in or Create an account to join the conversation.

5 years 7 months ago #3060 by MTR-Admin
Replied by MTR-Admin on topic Porter Cable BN200A
It depends on whether you feel the driving action is strong. If not, it could be the piston ring allowing air to pass.
The other issue is a possible damaged cylinder bumper that is protruding up and preventing the full length of the driver to do it's job. Also, is the driver blade and roll pin that attaches it to the piston in good position?

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.062 seconds