Engine rebuilders needed for advice

6 years 4 months ago #2221 by jensenbreck
Engine rebuilders needed for advice was created by jensenbreck
Hello all

this is my first post here. i am in the process of rolling in new main bearings on my 626. I used a screwdriver to tap the bearings in and I may have hit the end of the bearing a just a little to hard. Hard enough to leave a slight impression in the end of the bearing where it will crush against the other half in the cap.

Am I wasting my time putting this back together or do you guys think it will make no difference? I Really don't want to put it together if I'm just gonna be take it back apart.

Advice is much appreciated!

I didn't find the right solution from the internet.
References:

grassrootsmotorsports.com/forum/tech-tip...advice/132564/page1/

Video Explainer

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.090 seconds