compressor head on C-H VT558702AJ

10 years 8 months ago #393 by jkobilka
compressor head on C-H VT558702AJ was created by jkobilka
I took the top plate off of the pump due to non-pump symptom, found a flapper reed valve had come loose. Looked up the model & breakdown on this site, saw a flapper valve and a limiter. My unit appears to only have one of these flapper reeds for each cylinder, as there is one intact to look at, not a flapper and limiter as shown.....what do you think of this? (this unit is really old (serial 112884L-253581)

Please Log in or Create an account to join the conversation.

10 years 8 months ago #394 by MTR-Admin
Replied by MTR-Admin on topic compressor head on C-H VT558702AJ
Thanks for the post Jeff.

Well, this is an older "VT" series pump made by Campbell, and it should have a total of 6 Valves. On top of the Head, you have the Valve Cover Plate, of course, which covers 2 of these Valves. If you take the entire cast iron Head off, however, there should be 4 more Valves screwed to the bottom of the head.

Your pump should look like the Pump diagram on our website, can you click on the below link to confirm?
Thanks!
www.mastertoolrepair.com/campbell-hausfe...01-pump-p-36675.html

- MTR

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.039 seconds