- Posts: 9
- Thank you received: 0
8.7GA12 pump spewing oil from pump
- herschelm
- Topic Author
- Offline
- Fresh Boarder
Less
More
6 years 3 months ago #2502
by herschelm
8.7GA12 pump spewing oil from pump was created by herschelm
My 8.7GA12 pump is spewing oil from the vent hole near the engine-end of the pump. I only noticed because I came back to the pump to move it and found a puddle of light Gray oil. The pump was still working but I immediately shut it down. How much of this pump do you think I need to repair? It seems like the seal on the crankshaft of the pump is bad but what about the high pressure seals?
Thanks.
Thanks.
Please Log in or Create an account to join the conversation.
- MTR-Admin
- Offline
- Administrator
Less
More
- Posts: 1196
- Karma: 15
- Thank you received: 95
6 years 3 months ago #2506
by MTR-Admin
Replied by MTR-Admin on topic 8.7GA12 pump spewing oil from pump
How much use has this pump had would you estimate?
Please Log in or Create an account to join the conversation.
- herschelm
- Topic Author
- Offline
- Fresh Boarder
Less
More
- Posts: 9
- Thank you received: 0
6 years 3 months ago #2509
by herschelm
Replied by herschelm on topic 8.7GA12 pump spewing oil from pump
Not for sure but probably around 50 hours over 3 years.
Please Log in or Create an account to join the conversation.
- MTR-Admin
- Offline
- Administrator
Less
More
- Posts: 1196
- Karma: 15
- Thank you received: 95
6 years 3 months ago - 6 years 3 months ago #2510
by MTR-Admin
Replied by MTR-Admin on topic 8.7GA12 pump spewing oil from pump
I would make sure that the oil is from the pump and not from the engine crankshaft. If you are sure, then it could possibly be too much pressure build up in the pump. Does this happen when the pump is in use or just when you let your hand off of the gun handle?
This can also happen by worn out crankcase piston rods and seals as well as worn out plunger retainer o-rings. If this occurs, simply replace the rods and seals and o-rings with new ones.
This can also happen by worn out crankcase piston rods and seals as well as worn out plunger retainer o-rings. If this occurs, simply replace the rods and seals and o-rings with new ones.
Last edit: 6 years 3 months ago by MTR-Admin. Reason: Additional info
Please Log in or Create an account to join the conversation.
- herschelm
- Topic Author
- Offline
- Fresh Boarder
Less
More
- Posts: 9
- Thank you received: 0
6 years 3 months ago #2514
by herschelm
Replied by herschelm on topic 8.7GA12 pump spewing oil from pump
This is my third attempt to reply. Who do I talk to about getting the forum to NOT BLOW AWAY my work?
Please Log in or Create an account to join the conversation.
- herschelm
- Topic Author
- Offline
- Fresh Boarder
Less
More
- Posts: 9
- Thank you received: 0
6 years 3 months ago #2515
by herschelm
Replied by herschelm on topic 8.7GA12 pump spewing oil from pump
Oil in the engine is fine.
Please Log in or Create an account to join the conversation.
Moderators: MTR-Admin
Time to create page: 0.062 seconds