Bosch rotating anchor

9 years 1 month ago #1256 by Nilsi
Bosch rotating anchor was created by Nilsi
Ball bearings are shielded one side and sealed one side. Failed to notice what way they were installed. Now should the shielded side point inwards or outwards? This is a rotating anchor of an bosch table saw electric motor.

Please Log in or Create an account to join the conversation.

9 years 1 month ago #1257 by MTR-Admin
Replied by MTR-Admin on topic Bosch rotating anchor
Do you have the model number of the tool? This will greatly help.

Thanks,

- MTR

Please Log in or Create an account to join the conversation.

9 years 1 month ago #1258 by Nilsi
Replied by Nilsi on topic Bosch rotating anchor
Gts 10 (3601L30200)

Please Log in or Create an account to join the conversation.

9 years 1 month ago #1259 by MTR-Admin
Replied by MTR-Admin on topic Bosch rotating anchor
Thank you for the info, I'll do some research on this model and the question; I'll reply as soon as I have some info for you.

- MTR

Please Log in or Create an account to join the conversation.

9 years 1 month ago - 9 years 1 month ago #1264 by MTR-Admin
Replied by MTR-Admin on topic Bosch rotating anchor
This is a European model so I don't have a lot of information on it, I'm afraid.

However, "typically" the rubber seal side goes towards the area that would get dust and debris in it. A rubber seal protects more than a metal shield; also rubber is heat sensitive.

I hope this gives you some direction, but if you need additional technical assistance you can always contact Bosch Europe.

You can find out exactly how to contact a technical rep by choosing your country under the "Europe" banner, then proceeding from there:

www.bosch-pt.com/

- MTR

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.050 seconds