Craftsman 10 inch miter saw

9 years 11 months ago #815 by jake2leea
Craftsman 10 inch miter saw was created by jake2leea
Has anyone had any experience in replacing the arbor gear on a craftsman saw with a discontinued part listing? The saw is a 113.235200, the part is a 823251. Discontinued from sears. The gear on the arbor has a broken tooth, so all I really need is the gear. I'm not aware of any companies that can machine a new gear, but i'm sure it's been done before. Any suggestions would be greatly appreciated.

Please Log in or Create an account to join the conversation.

9 years 11 months ago #817 by MTR-Admin
Replied by MTR-Admin on topic Craftsman 10 inch miter saw
There isn't a whole lot you'd be able to do at this point I'd imagine, unfortunately.

I would check eBay, but even then it's a crapshoot.

A machine shop would probably charge as much for a new arbor gear as a new saw, honestly. I'll do some further research and if I get any positive hits at all, I'll reply and let you know.

Good luck and thanks for posting!

- MTR

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.042 seconds