Makita 18V Drill Troubles

10 years 4 months ago #603 by Disassemble to Reassemble
Makita 18V Drill Troubles was created by Disassemble to Reassemble
I have completely disassembled my makita 1/2" driver drill. It is an LTX model and I've gone so far as to disassemble the gear assembly. But I found two loose gears; thus the problem. I don't remember the order of the gears. Did I miss something? It seems like they're in the wrong order. The two loose gears didn't damage to planetary sets. Does anyone know where to find an exploded view of a 125831-7 gear set?

Please Log in or Create an account to join the conversation.

10 years 4 months ago #604 by MTR-Admin
Replied by MTR-Admin on topic Makita 18V Drill Troubles
Thanks for the post!

Can you reply with the Model# of the drill? Although 125831-7 is a good part#, there are a few drills this gear set fits.
Thanks!

- MTR

Please Log in or Create an account to join the conversation.

10 years 4 months ago - 10 years 4 months ago #605 by Disassemble to Reassemble
Replied by Disassemble to Reassemble on topic Makita 18V Drill Troubles
It's an LXFD01 model.

Please Log in or Create an account to join the conversation.

10 years 4 months ago #613 by MTR-Admin
Replied by MTR-Admin on topic Makita 18V Drill Troubles
Well I couldn't find this information, doesn't seem that it exists. Since I haven't torn one of these particular units apart, I'd recommend contacting a Technical Service Rep w/ Makita at 1-800-462-5482.

All the info I could find is at the below link:
www.makitatools.com/en-us/Modules/Tools/...ils.aspx?Name=LXFD01

- MTR

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.054 seconds