Hitachi Angle Nailer NT65MA2

6 years 4 months ago #2543 by RoyT
Hitachi Angle Nailer NT65MA2 was created by RoyT
My Hitachi 15 gauge angle nailer doesn't fire. When I depress the tip and pull the trigger, I get air leaking from the trigger area. The driver/ piston seems to seems to slide freely in the tube. I've replaced and greased just about every o ring in the entire gun including the trigger assembly. I've also replaced the head valve and bumper to no avail. What else can I check.

Please Log in or Create an account to join the conversation.

6 years 4 months ago #2548 by MTR-Admin
Replied by MTR-Admin on topic Hitachi Angle Nailer NT65MA2
Thanks for the post RoyT,

Based on what you've already replaced and if the nailer leaks from the trigger area, then the problem is most likely in the trigger valve or with the trigger valve itself.

However, it's difficult to diagnose it without seeing the unit itself.

- MTR

Please Log in or Create an account to join the conversation.

6 years 4 months ago #2550 by RoyT
Replied by RoyT on topic Hitachi Angle Nailer NT65MA2
Thanks. I will recheck the trigger assembly.

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.049 seconds