Senco 200R passing air

4 years 5 months ago #3300 by Garretthes
Senco 200R passing air was created by Garretthes
I just bought this coil nailer used and it worked great for a few coils then suddenly it stopped working and air is passing through the top. I opened the top and the plastic seal in the middle of the air vent has crumbled into pieces. What should I do? I can't find a specific rebuild kit online.
I need this gun working so I can finish my roof!

Please Log in or Create an account to join the conversation.

4 years 5 months ago #3302 by MTR-Admin
Replied by MTR-Admin on topic Senco 200R passing air
The parts you need are on this page here:
www.ereplacementparts.com/senco-scn200r-...1_117622_117740.html

Please Log in or Create an account to join the conversation.

4 years 5 months ago #3303 by Garretthes
Replied by Garretthes on topic Senco 200R passing air
Thanks but there are a thousand parts there. The problem is I'm not sure what part I need. I'm a pretty handy DIY guy but those drawings are hard to figure out. Also most every part I click on is discontinued or not available. I circled the part I think I need. It is discontinued. I circled it in yellow.
Attachments:

Please Log in or Create an account to join the conversation.

4 years 5 months ago #3304 by skatingtoolman
Replied by skatingtoolman on topic Senco 200R passing air
Try The New Yooper Workshop. He has lots of obsolete parts available.

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.129 seconds