- Posts: 2
- Karma: 1
- Thank you received: 0
Industry standard for pneumatic repair
- eraupike
- Topic Author
- Offline
- Fresh Boarder
Less
More
9 years 2 months ago #1117
by eraupike
Industry standard for pneumatic repair was created by eraupike
Does anyone know what the ANSI/NFPA standard is for pneumatic repair?
Please Log in or Create an account to join the conversation.
- MTR-Admin
- Offline
- Administrator
Less
More
- Posts: 1196
- Karma: 15
- Thank you received: 95
9 years 2 months ago #1122
by MTR-Admin
Replied by MTR-Admin on topic Industry standard for pneumatic repair
All I can find online is at the below link:
www.nfpa.org/codes-and-standards/document-information-pages
Not sure if this answers your question, but hopefully gets you closer to answering it.
- MTR
www.nfpa.org/codes-and-standards/document-information-pages
Not sure if this answers your question, but hopefully gets you closer to answering it.
- MTR
Please Log in or Create an account to join the conversation.
- eraupike
- Topic Author
- Offline
- Fresh Boarder
Less
More
- Posts: 2
- Karma: 1
- Thank you received: 0
9 years 2 months ago #1125
by eraupike
Replied by eraupike on topic Industry standard for pneumatic repair
Yes, I think that is what I had but I wasn't sure if there was something more specific. Elsmar Cove shutting down has been leaving us quality guys reeling.
Please Log in or Create an account to join the conversation.
- MTR-Admin
- Offline
- Administrator
Less
More
- Posts: 1196
- Karma: 15
- Thank you received: 95
9 years 2 months ago #1126
by MTR-Admin
Replied by MTR-Admin on topic Industry standard for pneumatic repair
That's what I hear, too bad
The only other resources I could find are below, maybe these forums will help:
qualityrecord.com/
www.oxebridge.com/emma/the-o-forum/
- MTR
The only other resources I could find are below, maybe these forums will help:
qualityrecord.com/
www.oxebridge.com/emma/the-o-forum/
- MTR
Please Log in or Create an account to join the conversation.
Moderators: MTR-Admin
Time to create page: 0.093 seconds