- Posts: 1
- Karma: 1
- Thank you received: 0
no pressure out of regulator
- Munchers60
- Topic Author
- Offline
- Fresh Boarder
-
Less
More
9 years 1 month ago #1262
by Munchers60
no pressure out of regulator was created by Munchers60
I have a emglo model# AM39-HC4V that I just replaced the regulator on. Tank pressure builds to 120psi. but 0 at the regulator. What's up?
Please Log in or Create an account to join the conversation.
- MTR-Admin
-
- Offline
- Administrator
-
Less
More
- Posts: 1196
- Karma: 15
- Thank you received: 95
9 years 1 month ago #1263
by MTR-Admin
Replied by MTR-Admin on topic no pressure out of regulator
Thanks for the post!
I know it may seem obvious, but did you install the regulator so that the arrow showing the outlet air direction is actually going to your hose?
There should be a small arrow showing the direction of air flow from the inlet to the outlet; must make sure you didn't reverse it so that the arrow points towards the inlet.
If you installed it with the arrow pointing towards the coupler/hose, then the regulator must be defective. If you get no pressure to the hose no matter how far clockwise you turn the knob, the diaphragm inside is probably stuck.
- MTR
I know it may seem obvious, but did you install the regulator so that the arrow showing the outlet air direction is actually going to your hose?
There should be a small arrow showing the direction of air flow from the inlet to the outlet; must make sure you didn't reverse it so that the arrow points towards the inlet.
If you installed it with the arrow pointing towards the coupler/hose, then the regulator must be defective. If you get no pressure to the hose no matter how far clockwise you turn the knob, the diaphragm inside is probably stuck.
- MTR
Please Log in or Create an account to join the conversation.
Moderators: MTR-Admin
Time to create page: 0.048 seconds