Emglo Air Compressor Fan

8 years 11 months ago #1001 by jr5455
Emglo Air Compressor Fan was created by jr5455
I have a Emglo 1.5hp hand carry compressor. I need to replace the fan. How do U get it off? I do not see a set screw or clip on it. I tried a puller but it hasn't moved.

Please Log in or Create an account to join the conversation.

8 years 11 months ago #1002 by MTR-Admin
Replied by MTR-Admin on topic Emglo Air Compressor Fan
Thanks for the post!

The easiest way to do it is to use some 3-arm bearing pullers and grab behind the fan on its hub, and remove it this way.

It's pressed onto the shaft so there is no key or set screw. Removing it with bearing pullers is certainly the easiest way. You can apply heat to the shaft as this will make it easier to remove, just make sure there are no rubber/plastic components that can melt.

Hope this helps!

- MTR

Please Log in or Create an account to join the conversation.

8 years 11 months ago #1004 by jr5455
Replied by jr5455 on topic Emglo Air Compressor Fan
Thank's, I did it with a 2 jaw puller and heat. It was hard to get off but it worked. Like this site and will be back when I have another problem.

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.083 seconds