Kellogg 321 Piston Ring Kit Install

7 years 7 months ago #2036 by kurtjohnson
Kellogg 321 Piston Ring Kit Install was created by kurtjohnson
Hi,
I have my new rings from you. My old rings had no chamfers at all.
There are inside chamfers, and the letters DY stamped on the new ones.
What is the correct orientation of these chamfers on both pistons for each groove?

Please Log in or Create an account to join the conversation.

7 years 7 months ago #2037 by MTR-Admin
Replied by MTR-Admin on topic Kellogg 321 Piston Ring Kit Install
Thanks for the post Kurt,

I'm not 100% positive so I'll contact my supplier and get the answer for you ASAP, assuming you still need the answer.

- MTR

Please Log in or Create an account to join the conversation.

7 years 7 months ago - 7 years 7 months ago #2038 by MTR-Admin
Replied by MTR-Admin on topic Kellogg 321 Piston Ring Kit Install
Kurt,

The surface where the letters "DY" appear face up when you install them on the piston. I've attached a very crude drawing, hopefully this helps.

I've also attached a photo of our Ring Kit. You would essentially install them as you see them in the photo, with the "DY" facing up. If I'm not mistaken, this means the inner chamfers would face inwards on the piston.

I hope this helps!

- MTR
Attachments:

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.043 seconds