compressor goes to 80psi and stops

9 years 7 months ago #960 by cheajt
compressor goes to 80psi and stops was created by cheajt
I have a Sanborn model 64A100-14 14 gal. Rated to 100 psi max, but only gets to 80psi and pump cuts off. Any ideas on how to fix this?

Please Log in or Create an account to join the conversation.

9 years 7 months ago #961 by MTR-Admin
Replied by MTR-Admin on topic compressor goes to 80psi and stops
You probably have a defective Pressure Switch, being this is the main component that controls the cut-in and cut-out pressure of the unit.

You can try adjusting the switch, first; most pressure switches are adjustable. If you click on the below link you'll see a video and a document that has instructions on how to do this for most brands of pressure switches:

www.mastertoolrepair.com/how-to-adjust-p...-switch-p-30582.html

If this doesn't work then I'd recommend replacing the switch. Most likely the diaphragm is damaged/corroded so it's not sensing the correct PSI.

Hope this helps!

- MTR

Please Log in or Create an account to join the conversation.

Moderators: MTR-Admin
Time to create page: 0.045 seconds