- Posts: 3
- Karma: 2
- Thank you received: 0
Husky H1506F type 1 replace piston ring
- travis119
- Topic Author
- Offline
- Fresh Boarder
-
Less
More
10 years 1 month ago #708
by travis119
Husky H1506F type 1 replace piston ring was created by travis119
I have H1506F type 1 , hows the easiest way to change the piston ring, should I take the piston off, then assemble and put rod first through sleeve and attached that way
Please Log in or Create an account to join the conversation.
- MTR-Admin
-
- Offline
- Administrator
-
Less
More
- Posts: 1196
- Karma: 15
- Thank you received: 95
10 years 1 month ago #709
by MTR-Admin
Replied by MTR-Admin on topic Husky H1506F type 1 replace piston ring
The easiest way to replace it is to:
1. Remove Conrod from the Cylinder.
2. Take the Piston Top off of the Rod (remove torx screw).
3. Remove old Piston Ring.
4. Replace new Piston Ring, with the convex side turned up.
5. Pull the Conrod/Piston Assy with no Ring down from the top of the Cylinder.
If you try to push the rod with new ring up from the bottom of the cylinder, most likely it will damage the piston ring.
I hope this helps!
- MTR
1. Remove Conrod from the Cylinder.
2. Take the Piston Top off of the Rod (remove torx screw).
3. Remove old Piston Ring.
4. Replace new Piston Ring, with the convex side turned up.
5. Pull the Conrod/Piston Assy with no Ring down from the top of the Cylinder.
If you try to push the rod with new ring up from the bottom of the cylinder, most likely it will damage the piston ring.
I hope this helps!
- MTR
Please Log in or Create an account to join the conversation.
Moderators: MTR-Admin
Time to create page: 0.043 seconds